Earl and the Aboveground Storage Tank Forum for fuel tanks, plastic tanks, fuel oil storage tanksWelcome to the aboveground storage tank forum, a bulletin board dedicated to tanks, fuel tanks, plastic tanks, fuel storage tanks, and above ground storage tanks (AST) API650, API653 & UL142 aboveground storage tanks (AST) and chemical plastic tanks. Remember the forum is made up of volunteers from experts to beginners. Unfortunately, we cannot allow free commercialism that promotes products, services, or sites.
 
Sponsored by:
Contact us about advertising

Tank Division

From: Juan C. [1270] 0 Stars
Date: Thursday, January 26, 2012
Time: 2:32:02 PM
Remote Name: 190.27.194.10

Comments

Dear Mr.

I am designing a TK API 650 that is 12 ft diam. x 36 ft high and is required to install a division sheet at the center so that it is divided into two, in order to handle two similar fluids lubricants, but you do not want to mix. The question is whether you have any recommendations or comments it deems important to consider for the design, manufacture and assembly of this plate boundary, as this is the first time I have this need and of course is not provided within the standard.

Thanks.

Silver Star Sponsors
    Tutorial on Pressure Vessel Safety Awareness        AIS Forensic Testing Laboratory Steel Making Tutorial Industrial Training School | Little Smokey's Bookstore at AIS Engineering Books | ASR Search Engine | Steam and Power Forum
Want to Advertise on the AST Forum
Confidentiality, Disclaimer & Policy
Copyright 2001-2012
All Rights Reserved; AST-FORUM.COM
Valid XHTML 1.0 Transitional