Earl and the Aboveground Storage Tank Forum for fuel tanks, plastic tanks, fuel oil storage tanksWelcome to the aboveground storage tank forum, a bulletin board dedicated to tanks, fuel tanks, plastic tanks, fuel storage tanks, and above ground storage tanks (AST) API650, API653 & UL142 aboveground storage tanks (AST) and chemical plastic tanks. Remember the forum is made up of volunteers from experts to beginners. Unfortunately, we cannot allow free commercialism that promotes products, services, or sites.
 
Sponsored by:

Contact us about advertising

Re: weld passes of bottom plate

From: BABRTs 973 [53] 5 Stars
Date: Thursday, March 10, 2011
Time: 11:46:35 AM
Remote Name: 12.183.137.72

Comments

I read the question to mean the floor plates. However I cannot find in the standard where two pass is required for either the floor plates or the corner weld. API 650 5.1.5.7 gives the fillet weld sizes.

Silver Star Sponsors
Tutorial on Pressure Vessel Safety Awareness AIS Forensic Testing Laboratory Steel Making Tutorial Industrial Training School | Little Smokey's Bookstore at AIS Engineering Books | ASR Search Engine | Steam and Power Forum
Want to Advertise on the AST Forum
Confidentiality, Disclaimer & Policy
Copyright 2001-2012
All Rights Reserved; AST-FORUM.COM
Valid XHTML 1.0 Transitional